DIY HIDE WIRES ON WALL TV

White horse sculpture | Metal decorative boxes | Rug At this phase, you can also ad a large conduit pipe which will make future fishing of wires much easier. I also ran all the necessary wires (and some extra ones) to accommodate all our consoles and any future ones we decided to add. Pre-construction setupīefore the drywall was hung, I made sure the electrician placed an outlet behind the TV. During our basement renovation, I knew I wanted to include this setup which allowed me to plan for it during the remodel.

DIY HIDE WIRES ON WALL TV

There is nothing cozier than a room with a TV above a fireplace! Unfortunately, it’s a little more complicated as the fireplace creates an obstacle for the wiring. Don’t forget to clean up the mess left behind after cutting into the drywall! Hiding TV wires in the wall above a fireplace Now all that’s left to do is to hang the TV back up, slide the console table back where it belongs, and turn the power back on. Connect plugsĪt this point, you can connect the power cord from the inlet on the bottom to the regular outlet the TV was plugged into before. The recessed outlet box is great for the tight space behind furniture and prevents cable pinching. When you hide TV wires in wall spaces with this cable management kit, the recessed boxes that come with it help the TV sit as flush to the wall as the mount will allow it. When you turn the screws, the plastic tabs on the back of the box tighten against the drywall to hold the box in place. You will need your drill and bits to attach the boxes to the wall. All you have to do is connect the ends of the Romex wire to the corresponding piece in the back of the recessed wall box – as seen below. The Romex wire that comes with the kit doesn’t require a conduit and is rated to be safely run behind the wall. To feed the cable, start from the top hole and send the wire down to the bottom hole and pull it through. Cut holes, feed wires, and attach platesĬut along the outline you made for your boxes to make the holes. Helpful tip: It should be pretty obvious, but if it looks close, measure the length of the cords you will be using beforeyou cut into the drywall. Tape measure – What DIY project doesn’t include measuring? Here you will need to accurately measure the openings in the drywall and mark the distance between the two.Drill and drill bits – You’ll need these to attach the wall plates where the cables will go into and out of the wall.Cutting tool – A jab saw or a simple box cutter with a razor blade will do the trick.It’s simple to use and helps to prevent you from accidentally cutting into the drywall too close to a stud. Stud finder – A magic little gadget that detects the studs behind the drywall.Here is what I’ve used that made the job a piece of cake. You need only a few tools and you likely already have them on hand. This is a relatively easy DIY project if you have some basic knowledge of how power cables and data cables work. However, if you are the DIY type, you can avoid hiring an electrician by using this very easy and safe cable management kit sold on Amazon. It should be a small fee and is totally worth it.ĭo NOT attempt to hardwire an outlet yourself. It is an easy job without additional cutting into your wall required. In order to plug in your TV, you’d need a licensed electrician to add an outlet behind the TV. Typically outlets are at the bottom of the wall. There are no obstacles behind the wall to work around so it’s a straightforward job. It represents a standard TV setup where both the power and signal wires run between studs and straight down. In order to hide the wires, you’ll need to create an opening behind the TV for the cables to go in and one down below for them to come out.Ĭheck out the diagram above. Obviously, hiding TV wires in the wall is the easiest during a renovation before the drywall goes up. Hiding TV wires in the wall above a fireplace.Cut holes, feed wires, and attach plates.

Diy hide wires on wall